Siemens SINUMERIK 840D sl Programming Manual page 307

No. Screen Cycle pa‐
form param‐ rameters
eters
3 Selection
S_KNUM1
4 Icon+
S_PRNUM
number
5 X0
S_SETV
6 X
S_MA
7 X1
S_SZA
8 Y1
S_SZO
9 DFA
S_FA
10 TSA
S_TSA
11 Measure‐
S_NMSP
ments
12 T
S_TNAME
13 DL
S_DLNUM
14 TZL
S_TZL
15 DIF
S_TDIF
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Meaning
Correction in tool offset
2), 4)
Val‐ UNITS:
ues:
TENS:
HUNDREDS:
0 = No correction
1 to max. 999 D numbers (cutting edge numbers) for tool offset;
for additive and setup offset, see also S_DLNUM
THOUSANDS: 0 or unique D numbers
TEN THOUSANDS: 0 or unique D numbers
1 to max. 32000, if unique D numbers in MD have been set up
HUNDRED THOUSANDS: Tool offset
0 = No specification (offset tool geometry)
1 = Offset of length L1
2 = Offset of length L2
3 = Offset of length L3
4 = Radius offset
ONE MILLION: Tool offset
0 = No specification (offset of the tool length wear)
1 = Tool offset, additive offset (AO)
Tool offset value is added to the existing AO
2 = Tool offset, setup offset (SO)
SO (new) = SO (old) + AO (old) offset value, AO (new) = 0
3 = Tool offset, setup offset (SO)
Tool offset value is added to the existing SO
4 = Tool offset, geometry
TEN MILLION: Tool offset
0 = No specification (offset in tool geometry normal, not inverted)
1 = Offset inverted
Number of the field of the probe parameters (not probe number)
(default=1)
Setpoint
Number of the measuring axis (default=1)
Val‐ 1 = 1st axis of the plane (for G18 Z)
ues: 2 = 2nd axis of the plane (for G18 X)
3 = 3rd axis of the plane (for G18 Y)
Bypass distance in the measured axis
Bypass distance in the bypass axis
Measurement path
Safe area
Number of measurements at the same location
Tool name
2)
Setup additive offset DL number
Work offset
2), 4)
Dimensional difference check
4.1 Overview of measuring cycle parameters
2)
2)
5)
5)
5)
2)
8)
(default=1)
2)
5)
2), 4)
Parameter lists
307