Siemens SINUMERIK 840D sl Programming Manual page 79

The "3D" soft‐
key is dis‐
played if bit
1 = 1 is set in
the general
SD 54760
$SNS_MEA_
FUNC‐
TION_MASK
_PIECE.
The following softkeys are only displayed if the "Turning" extended technology is set (channel-
specific MD52201 $MCS_TECHNOLOGY_EXTENSION = 1).
See also
Calibrate probe - calibrate in groove (CYCLE973) (Page 88)
Turning measurement - front edge (CYCLE974) (Page 92)
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
→
→
→
Measuring variants
3.1 General requirements
Outer circle segment (CYCLE979)
(Page 190)
Align plane (CYCLE998)
(Page 195)
Sphere (CYCLE997) (Page 200)
3 spheres (CYCLE997)
(Page 205)
Spindle angular displacement (CY‐
CLE995) (Page 210)
The "Angular deviation spindle"
softkey is only displayed in the G
code program.
3D - kinematics (CYLE996)
(Page 214)
The "Kinematics" softkey is only
displayed in the G code program if
the "Measure kinematics" option is
set.
Calibrate probe (CYCLE971)
(Page 281)
Milling tool or drill (CYCLE971)
(Page 287)
Milling tool or drill (CYCLE971)
(Page 287)
Turning tool (CYCLE982)
(Page 261)
79