Siemens SINUMERIK 840D sl Programming Manual page 324

Parameter lists
4.1 Overview of measuring cycle parameters
No Screen Cycle pa‐
. form param‐ rameters
eters
3 Selection
S_KNUM1
4 Icon+
S_PRNUM
number
5 X0
S_SETV
6 DFA
S_FA
7 TSA
S_TSA
8 X0
S_CPA
9 Y0
S_CPO
10 alpha 0
S_STA1
11 Alpha 1
S_INCA
12 Measure‐
S_NMSP
ments
13 T
S_TNAME
14 DL
S_DLNUM
15 TZL
S_TZL
16 DIF
S_TDIF
17 TUL
S_TUL
18 TLL
S_TLL
324
Meaning
Correction in tool offset
2)
Val‐ UNITS:
ues:
TENS:
HUNDREDS:
0 = No correction
1 to max. 999 D numbers (cutting edge numbers) for tool offset; for additive and
setup offset, see also S_DLNUM
THOUSANDS: 0 or unique D numbers
TEN THOUSANDS: 0 or unique D numbers
1 to max. 32000 if unique D numbers in MDs have been set up
HUNDRED THOUSANDS: Tool offset
0 = No specification (offset in tool radius)
1 = Offset of length L1
2 = Offset of length L2
3 = Offset of length L3
4 = Radius offset
ONE MILLION: Tool offset
0 = No specification (offset of the tool radius wear)
1 = Tool offset, additive offset (AO)
Tool offset value is added to the existing AO
2 = Tool offset, setup offset (SO)
SO (new) = SO (old) + AO (old) offset value, AO (new) = 0
3 = Tool offset, setup offset (SO)
Tool offset value is added to the existing SO
4 = Tool offset, geometry
TEN MILLION: Tool offset
0 = No specification (offset in tool geometry normal, not inverted)
1 = Offset inverted
Number of the field of the probe parameters (not probe number)
(value range 1 to 40)
Setpoint
Measurement path
Safe area
Center point of the 1st axis of the plane (for G17 X)
Center point of the 2nd axis of the plane (for G17 Y)
Starting angle
7)
Incremental angle
8)
Number of measurements at the same location
Tool name
2)
Setup additive offset DL number
Work offset
1), 2)
Dimensional difference check
Upper tolerance limit (incremental to the setpoint)
Lower tolerance limit (incremental to the setpoint)
2)
2)
5)
5)
5)
2)
(value range 1 to 9)
1)
1), 4)
1), 2)
2)
2)
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Measuring cycles