Milling Tool Or Drill (Cycle971) - Siemens SINUMERIK 840D sl Programming Manual

ShopTurn program
Parameter Description
Y Start point Y of the measurement mm
Z Start point Z of the measurement mm
List of the result parameters
The measuring variant "Calibrate probe" provides the following result parameters:
Table 3-45
Parameters
_OVR [8]
_OVR [10]
_OVR [12]
_OVR [14]
_OVR [16]
_OVR [18]
_OVR [9]
_OVR [11]
_OVR [13]
_OVR [15]
_OVR [17]
_OVR [19]
_OVR [27]
_OVR [28]
_OVI [2]
_OVI [3]
_OVI [5]
_OVI [9]
3.6.3

Milling tool or drill (CYCLE971)

Function
With this measuring version, the tool length or the tool radius of milling and drilling tools can
be measured. With milling tools, optionally the cutting edge length or the cutting edge radius
can be measured (e.g. to check whether individual cutting edges of the milling tool have been
broken out), see Section, "individually check teeth".
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Unit
"Calibrate probe" result parameters
Description
Trigger point in minus direction, actual value of 1st geometry axis
Trigger point in plus direction, actual value of 1st geometry axis
Trigger point in minus direction, actual value of 2nd geometry axis
Trigger point in plus direction, actual value of 2nd geometry axis
Trigger point in minus direction, actual value of 3rd geometry axis
Trigger point in plus direction, actual value of 3rd geometry axis
Trigger point in minus direction, difference of 1st geometry axis
Trigger point in plus direction, difference of 1st geometry axis
Trigger point in minus direction, difference of 2nd geometry axis
Trigger point in plus direction, difference of 2nd geometry axis
Trigger point in minus direction, difference of 3rd geometry axis
Trigger point in plus direction, difference of 3rd geometry axis
Work offset range
Safe area
Measuring cycle number
Measuring version
Probe number
Alarm number
Measuring variants
3.6 Measure tool (milling)
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
-
-
-
287