Siemens SINUMERIK 840D sl Programming Manual page 145

Parameter Description
Data set empiri‐ ● Without (do not use empirical values)
cal value
● 1-20 (data set for empirical value)
Data set aver‐ Without (do not generate average value)
age value
1-20 (data set for average value generation)
TMV Range for correction with average value generation
FW Weighting factor for averaging
Measurements Number of measurements at the same location
The "3D probe with spindle reversal" function is shown if bit 16 is set in the general SD 54760
1)
$SNS_MEA_FUNCTION_MASK_PIECE .
The "Align 3D probe" function is shown if bit 17 is set in the general SD 54760 $SNS_MEA_FUNCTION_MASK_PIECE .
2)
Other parameters and correction targets can be set in the general SD 54760 $SNS_MEA_FUNCTION_MASK_PIECE .
3)
Measuring variant, turning on a milling machine (only 840D sl)
Procedure
The part program or ShopTurn program to be edited has been created and you are in the editor.
Parameter
ShopTurn program
Parameters
T
D
Measuring method
X
Y
Z
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Machine manufacturer
Please observe the information provided by the machine manufacturer.
1. Press the "Meas. workp." softkey.
2. Press the "Edge distance" softkey.
3. Press the "Groove" softkey. The input window "Measure: Groove"
opens.
Description
Name of the probe
Cutting edge number (1 - 9)
● Standard measuring method
● 3D probe with spindle reversal
● Align 3D probe
Calibration data set (1 - 40)
(only for measuring without spindle reversal)
Start point X of the measurement
Start point Y of the measurement
Start point Z of the measurement
3.3 Measure workpiece (milling)
1)
2)
Measuring variants
Unit
-
-
-
-
-
Unit
-
-
-
-
mm
mm
mm
145