Siemens SINUMERIK 840D sl Programming Manual page 260

Measuring variants
3.5 Measure tool (turning)
Measuring variant, milling on the turning machine
Procedure
The part program or ShopMill program to be edited has been created and you are in the editor.
Parameter
ShopMill program
Parameter Description
T Name of the probe
D Cutting edge number (1 - 9)
Calibration data set (1 - 6)
F Calibration and measuring fee‐
drate
X Start point X of the measurement mm
Y Start point Y of the measurement mm
Z Start point Z of the measurement mm
List of the result parameters
The measuring variant "Calibrate probe" provides the following result parameters:
Table 3-38
Parameters
_OVR[8]
_OVR[10]
_OVR[12]
_OVR[14]
_OVR[9]
_OVR[11]
_OVR[13]
_OVR[15]
_OVR[27]
_OVR[28]
_OVI[2]
_OVI[3]
_OVI[5]
_OVI[9]
260
1. Press the "Meas. tool" softkey.
2. Press the "Calibrate probe" softkey.
"Calibrate probe" result parameters
Description
Trigger point in minus direction, actual value of 1st axis of the plane
Trigger point in plus direction, actual value of 1st axis of the plane
Trigger point in minus direction, actual value of 2nd axis of the plane
Trigger point in plus direction, actual value of 2nd axis of the plane
Trigger point in minus direction, difference of 1st axis of the plane
Trigger point in plus direction, difference of 1st axis of the plane
Trigger point in minus direction, difference of 2nd axis of the plane
Trigger point in plus direction, difference of 2nd axis of the plane
Zero offset area
Safe area
Measuring cycle number
Measuring variant
Probe number
Alarm number
Unit
-
-
-
mm/min
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
-
-
-
-
Measuring cycles