Using A Wheelchair; Changing Prosthesis Settings - Otto Bock Kenevo 3C60 Instructions For Use Manual

→ This MyMode (2. Bicycle ergometer)is shown in the overview in the Cockpit app.
Activating the "Bicycle ergometer" MyMode (activity mode C)
1) Sit on the bicycle ergometer.
2) Put the feet on the pedals.
3) Perform pedaling movements or activate the "2.Bicycle ergometer" MyMode using the Cock­
pit app.
→ After a few pedaling movements, these are recognised by the knee joint and a short beep
and vibration signal is produced. If this signal is not produced, the prerequisites for activ­
ating this MyMode were not met.
→ The short beep and vibration signal is produced periodically at intervals during the pedal­
ing movement until the resistances in the flexion and extension direction have been
reduced to the extent that the knee joint moves freely.
→ This MyMode (2. Bicycle ergometer) is shown in the overview in the Cockpit app.
Deactivating the "Bicycle ergometer" MyMode (activity mode A, B, B+, C)
► From the sitting position, either extend the knee or take the foot off the pedal and put it on the
floor. The foot has to be ahead of the knee joint when it is set on the floor.
→ This is recognised by the knee joint and a long beep and vibration signal is produced. If
this signal is not produced, either repeat the process or switch to the "1. Basic Mode"
MyMode using the Cockpit app.
→ This MyMode is shown in the overview in the Cockpit app.

8.5 Using a wheelchair

When sitting in a wheelchair, the joint can be locked in the flexed position for short distances. The
lock can be engaged in any position from an angle of 45°. This prevents the foot from dragging on
the floor. To use this function, it must be enabled in the adjustment software.
INFORMATION
Turning the "Wheelchair function" function off/on using the Cockpit app
If the "Locking function for wheelchair" function was turned on in the adjustment software,
the "Wheelchair function" function can be turned off and back on again using the Cockpit
app.

8.6 Changing prosthesis settings

Once an active connection to a component has been established, the settings of the respective
active mode can be changed using the Cockpit app.
INFORMATION
Bluetooth on the prosthesis has to be switched on to change the prosthesis settings (see
page 80).
78
Locking the joint
► Raise the foot and hold it still in the desired position.
The lock engages automatically.
INFORMATION: At full extension, the lock engages in a slightly
flexed position so the foot can be lifted in order to release the lock.
Disengaging the lock
The lock can be disengaged in the following ways:
• Extended pressure on the ball of the foot.
• Extended pressure on the toes (from the top of the foot).
• Lift the foot (extend the knee) and allow the foot to lower again.