Table of Contents
Advertisement
CDE360 Vector Control AC Drive
Chapter 3 Mechanical and Electrical Installation
3.1 Mechanical Installation
3.1.1 Requirements of Installation Environment
Item
1
Good ventilation.
Ambient temperature: -10℃ ～40℃.
2
Free from high temperature, humidity (less
3
than 95%RH), no rainwater or other liquid drip.
4
Free from combustible objects, such as woods.
3.1.2 Installation Direction and Clearance
To ensure the heat dissipation of the product, please install the product vertically according to the
following figure and never invert the installation.
When the installation is in the cabinet, try to use the mode of side-by-side installation. At the same
time, to facilitate the heat dissipation, you should ensure that there is enough space around.
A
Single unit mode
Remarks during the mechanical installation:
1) Please install the AC drive vertically. If there are several AC drives in the cabinet, try to use the
mode of side-by-side installation. When the cooling space can be guaranteed, please consider
the cooling requirements of other components.
2) As for the installation clearance, please refer to Table 3-1.
3) For occasions which have upper and lower installation, please refer to Figure 3-1 and install the
insulation guidance plate.
4) Please use the installation holder which contains incombustible materials.
5) For occasions which have metal powder, it is suggested that the heat sink is installed outside the
cabinet.
Requirements
B
A
B
Figure 3- 1 CDE360 installation diagram
Table 3- 1 The dimension size of the installation clearance
AC drive power class
（kW）
≤ 15
18.5～30
≥ 37
Chapter 3 Mechanical and Electrical Installation
Item
5
Free from direct sunlight.
6
Free from combustible, corrosive gas and liquid.
7
Free from dust, oil dirt, floating fiber and metal powder.
8
The installation base is stable with no vibration.
9
Free from magnetic interference.
≥100mm
Up and down mode
Installation size（mm）
A
≥ 30
≥ 50
19
-
-
Guide plate
B
≥ 100
≥ 200
≥ 300
Advertisement
Table of Contents
