Group B0: Basic Parameters - Canworld CDE360 Series Manual

CDE360 Vector Control AC Drive
running hour
upon latest fault
The parameters of A1.12~A1.23 are the penultimate fault record, the mean of these
parameters same as A1.00~A1.11
The parameters of A1.24~A1.35 are the third fault record, the mean of these parameters same
as A1.00~A1.11

Group b0: Basic Parameters

①
b0.00
Maximum
frequency
①
b0.01
Source of Upper
limit frequency
b0.02
Digital setting of
upper limit
frequency
b0.03
Lower limit
frequency
Note: the parameters of max frequency, upper limit frequency and lower limit frequency should
be set based on the motor. The relationship of these parameters is max frequency ≥upper limit
frequency≥lower limit frequency.
b0.04
Acceleration
time 1
Total accumulative running time upon latest fault is A1.10+A1.11
Range: 30.00~650.00
Unit: Hz
The parameter define the Max allowable output frequency. it is the
reference of some frequency setting, but also the acceleration and
deceleration time. Please set up suitable value in the actual application
filed.
Range: 0~5
Please select suitable value according to the actual demand.
0: b0.02
3: AI3
Range: b0.03~b0.00
Unit: Hz
The upper limit frequency is used to set the maximum allowable output
frequency, its value should be less than or equal to the maximum
frequency. When setting frequency is higher than the upper limit
frequency, drive will run in the upper limit frequency.
Range: 0.00~b0.02
Unit: Hz
The lower limit frequency is used to set the allowable minimum frequency
of the motor running, its value should be less than or equal to the upper
limit frequency. When setting frequency less than the lower limit of
frequency converter, the run mode according to the b1.17.
Range: 0.1~6000.0
Unit: Sec
Acceleration time indicates the time required by the drive to accelerate
1: AI1
4: X6/FI
95
- -
Chapter 6 Parameters Description
Default: 50.00
Default: 0
2: AI2
5: Communication setting
Default: 50.00
Default: 0.00H
Default: Model dependent