Group E1: Skip Frequency - Canworld CDE360 Series Manual

CDE360 Vector Control AC Drive
E0.03
JOG stop mode
E0.04
JOG preferred

Group E1: Skip Frequency

If the set frequency is within the frequency jump range, the actual running frequency is the skip
frequency close to the set frequency. Setting the skip frequency helps to avoid the mechanical
resonance point of the load.
The AC drive supports two skip frequencies. If both are set to 0, the skip frequency function
is disabled.
E1.00
Skip frequency
1 high limit
E1.01
Skip frequency 1
low limit
E1.02
Skip frequency 2
high limit
E1.03
Skip frequency 2
low limit
Note: The AC drive can output in the skip frequency range during acceleration and
deceleration process.
The principle of the skip frequencies is shown in the following figure.
Range: 0~1
0: Ramp stop
Range: 0~1
When set E0.04 to 1,the AC drive will response the JOG command of
current control source immediately even if in running state.And the JOG
command form other control source will be ignored.
0: Disabled
Range: E1.01~b0.00
Unit: Hz
As shown in the following figure.
Range: 0.00~E1.00
Unit: Hz
As shown in the following figure.
Range: E1.03~b0.00
Unit: Hz
As shown in the following figure.
Range: 0.00~E1.02
Unit: Hz
As shown in the following figure.
输出频率Hz
跳跃频率幅度
跳跃频率2
跳跃频率幅度
跳跃频率1
Principle of the skip frequency
Figure 6- 32
1: Coasting stop
1: Enabled
跳跃频率幅度
跳跃频率幅度
Chapter 6 Parameters Description
Default: 0
Default: 0
Default: 0.00
Default: 0.00
Default: 0.00
Default: 0.00
时间t