Group C3: Analog Output - Canworld CDE360 Series Manual

CDE360 Vector Control AC Drive
Note:

When the analog input greater than the maximum analog input(C2.06,C2.10), the
corresponding setting is decided by the maximal input corresponding setting.

When the analog input below the minimum input, the corresponding parameter
setting determined by C2.22.

Group C3: Analog Output

C3.00
AO1 filter time
C3.01
AO2 filter time
C3.02
AO1 function
C3.03
AO2 function
AO1 and AO2 can select 0~10V voltage mode or 0~20mA current mode by the terminal CJ3 and
CJ4 which on control board.
lower than the minimum input, the corresponding setting is decided by the
minimum input corresponding setting(C2.05,C2.09).
1: 0.0%；When the AI signal is lower than the minimum input, the
corresponding setting is 0%.
Unit's digit: AI1
Range: 0.00~10.00
Unit: Sec
The parameter is used to set the software filter time of AO1. If the analog
output is liable to interference, increase the value of this parameter to
stabilize the detected analog output. However, increase of the AO filter
time will slow the response of analog detection. Set this parameter
properly based on actual conditions.
Figure 6- 17 Analog output 1 filter
Range: 0.00~10.00
Unit: Sec
Same as C3.00.
Range: 0~17
The parameter defined the AO1 function,as the table below.
Range: 0~17
The parameter defined the AO2 function,as the table below.
Ten's digit: AI2
Chapter 6 Parameters Description
Hundred's digit: AI3
Default: 0.00
Default: 0.00
Default: 1
Default: 2