Digi Connect WAN Series User Manual page 37

Digi Connect WAN Family web interface
Socket Tunnel settings: Configure a socket tunnel used to connect two network devices: one
n
on the Digi Connect WAN Family device's local network and the other on the remote network.
See Socket tunnel settings
Virtual Private Network (VPN) settings: Configure the Virtual Private Network that securely
n
connect two private networks together so that devices may connect from one network to the
other network using secure channels. See
information.
IP Pass-through settings: Configure a Digi Connect WAN Family device to pass its mobile IP
n
address directly through and to the Ethernet device (router or computer) to which it is
connected through the Ethernet port. The Digi Connect WAN Family device becomes
transparent (similar to the behavior of a cable or DSL modem) to provide a bridge from the
mobile network directly to the end device attached to the Digi Connect WAN Family device. See
IP Pass-through settings
Host List settings: Add or remove entries from the host list. For DialServ, the host list provides
n
a means to map a phone number (in the local name field) to a network destination, (in the
"resolves_to" field). See
Virtual Router Redundancy Protocol (VRRP) settings: Configure a number of routers to
n
represent a virtual router, which simplifies configuration of hosts on a network.
Advanced Network Settings: Configure the Ethernet Interface speed and mode, IP settings,
n
TCP keepalive settings, and DHCP settings. See
information.
IP Settings
The IP Settings page allows you to configure how to obtain the IP address of the Digi Connect WAN
Family device. You can use one of the following methods to obtain the IP address:
DHCP
n
Static IP address
n
Subnet mask
n
Default gateway
n
For more information on how to assign and use these settings in your organization, contact your
network administrator.
IP settings
Obtain an IP address automatically using DHCP: When the Digi device is rebooted, it will
n
obtain new network settings.
Use the following IP Address: Choose this option to supply static settings. An IP address and
n
Subnet mask must be entered. Other items are not mandatory, but may be needed for some
functions (such as talking to other networks).
Digi Connect WAN Family User Guide
for more information.
Virtual Private Network (VPN) settings
for more information.
Host List Settings for more information.
Advanced Network Settings
Configuration through the web interface
for more
for more
37