Digi Connect WAN Series User Manual page 207

Troubleshooting
LED/button
Ethernet Link LED
Cellular or WiMAX Link LED
Cellular or WiMAX Activity
LEDs
Signal Strength LEDs
Status LED
Reset button
Digi Connect WAN Family User Guide
Color and Light
Pattern Activity Indicated
Solid yellow Ethernet link is available.
Blinking green Ethernet traffic is on
LEDs and buttons
Solid yellow Cellular or Wi-MAX link is available.
Blinking green Cellular or Wi-MAX traffic is on the link
0-4 LEDs Relative signal strength indicator (RSSI), shown
Amber or green
as a number of LEDs.
depending on
n
cellular signal
type
n
n
You can find specific dB values for the signal via
the web interface; go to Administration >
System Information > Mobile. Under Mobile
Connection, the signal strength appears in bars
and dBm. From the command line, type the
display mobile command.
Digi Connect WAN models have a feature where
the signal strength LEDs change colors to
indicate which type of cellular signal is detected.
Amber = 2G network
Green = 3G network
Blinks during product initialization and factory
reset, using the light patterns below. This LED
should never blink during normal operation. If it
blinks constantly, contact Digi Technical Support.
Solid red Initializing hardware.
1-1-1 blinking Initializing firmware.
green
1-5-1 blinking Device configuration has been restored to its
green factory defaults.
Other blinking Contact Digi Technical Support.
green
Solid green Device is powered on and ready for operation.
Single press: Performs equivalent of a power-
cycle.
Press and hold: Resets device configuration
settings to factory defaults (factory reset).
System status LEDs
Digi Connect WAN Family
the link.
0: signal strength unknown or
unacceptable
1: signal strength low/weak
4: signal strength high/excellent
207