Digi Connect WAN Series User Manual page 183

Digi Connect WAN Family command-line interface
Administration
You can issue commands from the command-line interface to administer Digi Connect WAN Family
products. The following table displays several administration tasks and the commands used to
perform them. See the Digi Connect® Family Command Reference for more complete command
descriptions.
Administrative task
Backup/restore a configuration from a
TFTP server on the network
Update firmware
Reset configuration to factory defaults revert
Display system information and
statistics
Reboot the device
Enable/disable network services
Digi Connect WAN Family User Guide
Command
backup
boot
To update the firmware:
1. Telnet to the Digi device command-line interface
using a telnet application or hyperterm.
2. If security is enabled for the Digi device, a login
prompt appears. The default user name is root and
the default password is dbps. If these defaults do
not work, contact the system administrator who
set up the device.
3. If you are at the bash shell, type configshell to get
to the config shell.
4. Issue the boot load command:
#> boot load= tftp-server-ip : filename
Replace tftp-server-ip with the IP address of the
TFTP server that contains the firmware, and
replace filename with the name of the file to upload.
or
boot action=factory
info
boot
set service
Administration
183