Digi Connect WAN Series User Manual page 180

Digi Connect WAN Family command-line interface
send mode
Use the send mode command to configure the telnet control commands. For example, send telnet
control command to last active telnet session or set telnet operating options.
set accesscontrol
Use the set accesscontrol command to limit network access (IP filtering) to the Digi device.
set alarm
Use the set alarm command to display alarm settings, including conditions that trigger alarms, and
how alarms are sent. You can configure alarms to be sent as either an email message, an SNMP trap,
or both. You can configure the alarms as needed.
set autoconnect
Use the set autoconnect command to configure the autoconnection behaviors for serial port
connections.
set buffer and display buffers
Use the set buffer command to configure buffering parameters on a port and display the current port
buffer configuration. The display buffers command displays the contents of a port buffer, or
transfers the port-buffer contents to a server running Trivial File Transfer Protocol (TFTP).
set forward
Use the set forward command to configure IP forwarding.
set host
Use the set host command to configure the host name for the Digi device.
set ia
Use the set ia command to configure the Industrial Automation/Modbus information.
set mgmtconnection
Use the set mgmtnetwork command to configure the Remote Manager connection settings.
set mgmtglobal
Use the set mgmtglobal command to configure the Remote Manager global settings.
set mgmtnetwork
Use the set mgmtnetwork command to configure the Remote Manager network settings.
set mobile
Use the set mobile command to configure the cellular communication settings.
Digi Connect WAN Family User Guide
Management through the command line interface
180