Digi Connect WAN Series User Manual page 182

Digi Connect WAN Family command-line interface
set system
Use the set system command to configure the system identifying information.
set tcpserial
Use the set tcpserial command to configure serial TCP.
set user
Use the set user command to configure a user.
set wlan
Use the set wlan command to configure wireless devices.
set wimax
Use the set wimax command to configure the Wi-MAX communication settings.
set wlan
Use the set wlan command to configure wireless devices.
status
Use the status command to display a list of sessions or outgoing connections made by the connect,
rlogin, or telnet commands for a Digi device. Use the status command to determine which of the
current sessions to close.
show
Use the show commands to display current settings on a Digi device.
telnet
Use the telnet command to establish an outgoing telnet connection, also known as a session.
vpn
Use the vpn command to manage Virtual Private Network (VPN) connections.
who and kill
Use the who command to display a global list of connections. The list of connections includes those
associated with a serial port or the command-line interface.
Use the kill command to terminate active connections based on the ID number returned from the
who results.
Use the who command to determine any connections that are no longer needed, and end the
connections by issuing a kill command.
Digi Connect WAN Family User Guide
Management through the command line interface
182