Digi Connect WAN Series User Manual page 118

Digi Connect WAN Family web interface
Send alarms based on serial data pattern matching: Click this radio button to specify that
n
this alarm is sent when the specified serial data pattern is detected. Then specify the following:
Serial Port: The serial port to monitor for the data pattern. This field appears for devices
l
where more than one serial port is available.
Pattern: When the serial port receives this data pattern it sends an alarm. You can include
l
special characters such as carriage return carriage return (\r) and new line (\n) in the data
pattern.
Send alarms based on average RSSI level below threshold for amount of time: Send
n
alarms based on the average signal strength falling below a specified threshold for a specified
amount of time.
RSSI: The threshold signal strength, measured in dB (typically -120 dB to -40 dB).
l
Time: The amount of time, in minutes, that the signal strength falls below the threshold.
l
Note The set alarms command has an option, optimal_alarms_enabled={yes|no} that, when
enabled, causes an optimal alarm to be sent when the signal strength returns to a value above
the specified threshold. This feature is only available through the command line. The default is
no; it must be explicitly enabled if desired.
Send alarms based on cellular data exchanged in an amount of time:
n
Data: The number of bytes of cellular data.
l
Time: The number of minutes.
l
Cell Data Type: Type of cellular data exchanged: receive data, transmit data, total data.
l
Alarm Destinations
Use the Alarm Destinations page to define how alarm notifications are sent, either as an email
message or an SNMP trap, or both, and where the alarm notification is sent.
Send E-mail to the following recipients when alarm occurs: Enable sending the alarm as an
n
email message. Then specify the following information:
To: The email address to which this alarm notification email message will be sent.
l
CC: The email address to which a copy of this alarm notification email message will be sent
l
(optional).
Priority: The priority of the alarm notification email message.
l
Subject: The text to be included in the Subject: line of the alarm-notification email.
l
Send SNMP trap to the following destination when alarm occurs: Specifies whether to
n
send the alarm as an SNMP trap. To send alarms as SNMP traps, you must set the Alarm Type
to snmptrap and specify the IP address of the destination for the SNMP traps in the SNMP
settings (Configuration > System > Simple Network Management Protocol). See
Network Management Protocol (SNMP)
the "Send alarm to SNMP destination" check box. You can also specify a secondary or backup
SNMP destination.
To configure an alarm notification to be sent as both an email message and an SNMP trap:
Digi Connect WAN Family User Guide
Configuration through the web interface
Settings. That destination IP address appears below
Simple
118