Digi Connect WAN Series User Manual page 177

Digi Connect WAN Family command-line interface
set pppoutbound
n
set profiles
n
set realport
n
set rtstoggle
n
set serial
n
set service
n
set snmp
n
set system
n
set tcpserial
n
set udpserial
n
set user
n
set wimax
n
close
Use the close command to close active sessions that were opened by connect, rlogin, and telnet
commands.
connect
Use the connect command to establish a connection with a serial port.
dhcp
The dhcp command manages DHCP server operation.
display
Use the display commands to display real-time information about a device, such as:
General product information, including the product name, MAC address, boot, post, and
n
firmware versions, memory usage, utilization, and uptime, or the amount of time since the
device was booted (display device).
Active interfaces on the system. These include the web interface, command line interface,
n
Point-to-Point Protocol (PPP), and Ethernet interface, and their status, such as Closed or
Connected (display netdevice).
Logged serial data (display logging/).
n
Memory usage information (display memory).
n
Serial modem signals (display serial).
n
Mobile connection information and statistics (display mobile).
n
Network Address Translation (NAT) information (display nat).
n
General status of the sockets resource (display sockets).
n
Digi Connect WAN Family User Guide
Management through the command line interface
177