Digi Connect WAN Series User Manual page 117

Digi Connect WAN Family web interface
Enable alarm notifications: Enables or disables all alarm processing for the Digi device.
n
Send all alarms to the Remote Management server: enables or disables sending of alarm
n
notifications to a server that handles remote management of devices, such as Remote
Manager.
Enabling this setting sends all alarm notifications to Remote Manager. Enable this option if the
Digi device is managed by a remote management server, such as Remote Manager. Enabling
this option is useful because it allows all alarms to be monitored from one location. Enabling
this option also allows Digi devices to send alarms to clients that would otherwise be
unreachable from the Digi device, either because the Digi device is behind a firewall or not on
the same network as the alarm destination.
When you disable this setting alarm notifications are not sent to Remote Manager. Disable this
setting if devices are not managed by a Remote Manager server or if alarms are sent from the
device. For example, an SNMP trap destination is local to the device, not Remote Manager.
Mail Server Address (SMTP): Specifies the IP address of the SMTP mail server. Ask your
n
network administrator for this IP address.
From: Specifies the text that used in the "From:" field for all alarms that are sent as emails.
n
Alarm list and status
The Alarm Conditions page lists all of the alarms. You can configure up to 32 alarms for a Digi device,
and you can individually enable and disable these alarms.
The alarm list displays the current status of each alarm. You can use this list to view alarm status at a
glance, then view more details for each alarm as needed.
Enable: The check box indicates whether the alarm is currently enabled or disabled.
n
Alarm: The number of the alarm.
n
Status: The current status of the alarm, which is either enabled or disabled.
n
Type: The basis for the alarm.
n
Trigger: The conditions that trigger the alarm.
n
SNMP Trap: Indicates whether the alarm is sent as an SNMP trap.
n
If the SNMP Trap field is disabled, and the Send To field has a value, the alarm is sent as an
l
email message only.
If the SNMP Trap field is enabled and the Send To field is blank, the alarm is sent as an
l
SNMP trap only.
If the SNMP Trap field is enabled, and a value is specified in the Send To field, that means
l
the alarm is sent both as an email and as an SNMP trap.
Send To: The email address to which the alarm is sent.
n
Email Subject: Text to include in the Subject line of alarms sent as email messages.
n
Alarm Conditions
Use the Alarm Conditions page to specify the conditions on which the alarm is based, such as Alarm
conditions include:
Digi Connect WAN Family User Guide
Configuration through the web interface
117