Digi Connect WAN Series User Manual page 178

Digi Connect WAN Family command-line interface
Active TCP sessions and active TCP listeners (display tcp).
n
Current UDP listeners (display udp).
n
Provisioning information currently in the Digi device device's CDMA module (display
n
provisioning).
Uptime information (display uptime).
n
Virtual Private Network (VPN) connection information (display vpn).
n
display mobile (cellular)
Use the display mobile command to display mobile (cellular) statistics.
display provisioning
Use the display provisioning command to provision CDMA cellular modules.
display wimax
Use the display wimax command to display Wi-MAX information and statistics.
exit and quit
Use the exit and quit commands to terminate a currently active session.
info
Use the info commands to display statistical information about a device over time. The statistics
displayed are those gathered since the tables containing the statistics were last cleared. The type of
statistics include:
Device statistics. The info device command displays such details as product, MAC address,
n
boot, POST, and firmware versions, memory usage, utilization, and uptime.
Ethernet statistics. The info ethernet command displays statistics regarding the Ethernet
n
interface, including:
The number of bytes and packets sent and received
l
The number of incoming and outgoing bytes that were discarded or that contained errors
l
The number of Rx overruns
l
The number of times the transmitter was reset
l
The number of incoming bytes when the protocol was unknown
l
ICMP statistics. The info icmp command displays the number of messages, bad messages, and
n
destination unreachable messages received.
Digi Connect WAN Family User Guide
Management through the command line interface
178