Table of Contents
Advertisement
Digi Connect WAN Family command-line interface
Serial statistics. The info serial command displays the following information:
n
Number of bytes received and transmitted
l
Signal changes
l
FIFO and buffer overruns
l
Framing and parity errors
l
Breaks detected
l
TCP statistics. The info tcp command displays the following information:
n
The number of segments received or sent
l
The number of active and passive opens
l
The number of bad segments received
l
The number of failed connection attempts
l
The number of segments retransmitted
l
The number of established connections that were reset
l
UDP statistics. The info udp command displays the following information:
n
The number of datagrams received or sent
l
The number of bad datagrams received
l
The number of received datagrams that were discarded because the specified port was
l
invalid
To display mobile statistics, use the display mobile command instead of the info command.
n
newpass
Use the newpass command to issue a new password to a user.
ping
Use the ping command to test whether a host or other device is active and reachable.
reconnect
Use the reconnect command to reestablish a connection opened by a connect, rlogin, or telnet
command. By default, the reconnect command reestablishes the connection to the last active
session.
rlogin
Use the rlogin command to sign in to a remote system.
send
Use the send command to send a telnet control command, such as break, abort output, are you there,
escape, or interrupt process, to the last active telnet session.
Digi Connect WAN Family User Guide
Management through the command line interface
179
Advertisement
Table of Contents
