Piper Malibu PA-46-310P Pilot Operating Handbook page 399

SECTION 9
SUPPLEMENT 4
(3) TILT
(4)
RANGE
12/30/60/90
(5)
Range Field
(6)
Test Field
(7)
Range Mark
Identifier
(8)
Mode Field
PIPER AIRCRAFT CORPORATION
PA-46-310P, MALIBU
Rotary control used to adjust antenna
elevation position. Control indexes incre-
ments of tilt from O to 12 degrees up or
'i.....,l
down.
Rotary switch used to select one of four
ranges.
Maximum selected range is displayed.
Maximum range is always displayed when
indicator is in on-condition.
Test block displays three illumination
levels.
Individual label displayed for each range
mark.
Operating mode is displayed as WX or
CYC.
When system is first turned on. WAIT is
\w,I
displayed until system times out (30-40
seconds).
(b) PRELIMINARY CONTROL SETTINGS
Place the Indicator controls in the following positions before
applying power from the aircraft electrical system:
MODE selector ..................................... OFF
lNTensity control .................... Fully counterclockwise
Tl LT control ................................ Fully upward
RANGE switch ........................... 12 nautical miles
(c) OPERATIONAL CONTROL SETTINGS
( I) Rotate MODE selector clockwise to SBY to bring system into
ON condition.
(2) Note that WAIT is displayed during warm-up period of
30-40 seconds.
(3) Rotate MODE selector to desired operating mode.
(4) Set RANGE switch to desired range.
(5) Adjust Tl LT control for desired forward scan area.
REPORT: VB-1200
ISSUED: JANUARY II, 1984
9-S8, 4
of
6