Piper Malibu PA-46-310P Pilot Operating Handbook page 370

PIPER AIRCRAFT CORPORATION
PA-46-3IOP, MALIBU
ENROUTE NAVIGATION
(a) Load Waypoint I Data
SECTION 9
SUPPLEMENT 2
(I) Put waypoint I in the DSP window by depressing the DSP
button. (If there is a 2 in the DSP window initially. push the
DSP button three times to go through the 2-3-4-1 sequence
to reach
I.)
The previously selected frequency (stored in memory) for
waypoint I will be displayed and .. , .. will be flashing unless
USE and DSP are the same.
(2) Select a waypoint I frequency using the data input controls
which are the two concentric knobs on the right. The smaller
of the 2 knobs controls the .I MHz and .05 MHz digits. The
outer knob changes the I MHz and IOM Hz displays. The
selected frequency
will appear in the display and be placed in
memory.
(3) Select a waypoint I radial by first depressing the DAT A button.
This will cause the radial for the previous waypoint I to appear
in the data display over the annunciation RAD. Select the
radial with the data input controls. The outer knob controls the
10° and 100° digits; the center knob IN position controls the
1° and the center knob OUT position controls the 0. 1° digit.
The selected radial will appear in the display and be placed in
memory.
(4) Select a waypoint I distance by again depressing the DATA
button. causing display of the previous waypoint I distance in
the data display overtheannunciation DST. Select thedistance
with the data input controls. Th~ outer knob controls the
IO NM digit, the center knob IN position controls the I NM
digit, and the center knob OUT position controls the 0.1 NM
digit. The selected distance
will
appear in the display and be
placed in memory.
ISSUED: JANUARY 11,
1984
REPORT: VB-1200
3 of 14, 9-31