Piper Malibu PA-46-310P Pilot Operating Handbook page 387

SECTION 9
SUPPLEMENT
3
(e) INFLIG HT
PIPER AIRCRAFT CORPORATION
PA-46-3IOP, MALIBU
( 1) Preset waypoints may be recalled from memory and put into
active use as required.
Turn the WPT knob as required to select the desired waypoint.
'.,,I
The preset waypoint number~ frequency. radial and distance
will appear in their respective displays. The WPT display
will blink to indicate that the waypoint displayed is other
than the active waypoint.
(2) Verify that the data is correct.
NOTE
Revisions to the waypoint data can be pro-
grammed at this time by entering the new
waypoint parameters.
(3) When return to the active waypoint is desired press the RTN
button. The active waypoint. along with its data. will be
displayed.
(4) When navigation to the displayed (blinking WPT) waypoint is
desired. press the USE button. The WPT display will cease
blinking and the displayed waypoint becomes the active
1....,,)
waypoint.
RNA V OPERATION
If
the system is receiving valid signals from a co-located VOR-DME
facility, it will supply linear deviation information to the Horizontal Situa-
tion Indicator (or Course Deviation Indicator). Enroute (RNV) sensitivity.
available by turning the MODE selector knob until RNV is displayed.
provides a constant course width of±
5
NM full scale.
Approach (RNV APR) sensitivity, available by turning the MODE
selector knob until RNV APR is displayed, provides a constant course width
of± l
Y4
NM full scale. Approach sensitivity should be selected just prior to
final approach course interception. Time and distance to the station, and
computed ground speed are displayed on the DME display.
REPORT: VB-1200
ISSUED: JANUARY II, 1984
9-46, 4 of 12