Piper Malibu PA-46-310P Pilot Operating Handbook page 343

BENDIX/KING
SBCTION 4
NORMAL PROCEDURES
3) Heading Selector Knob - ROTATB Bug to agree
with OBS course.
NOTE
VHEN APR IS SELECTED, THE LATERAL OPERATING MODE VILL CHANGE
FROM BDG (IF SELECTED) TO VINGS LEVEL FOR 5 SECONDS. A 45°
INTERCEPT ANGLE VILL THEN BE AUTOMATICALLY ESTABLISHED BASED ON
THE POSITION OF THE BUG.
a) If the D-Bar is greater than
2
to 3
dots: the autopilot will annunciate
BDG
mode (unless
BDG
not selected) and
APR flashing; when the computed capture
point is reached the
HDG
annunciator
will go out, the APR annunciator will
illuminate steady and the selected
course will be automatically captured
and tracked.
b) If the D-Bar is less than 2 to 3 dots:
the
HOG
mode will disengage upon
selecting APR mode; the APR annunciator
will illuminate steady and the capture/
track sequence will automatically
begin.
8. BC Approach Coupling
a. Vhen equipped with HSI
1) Course Bearing Pointer - SET to the ILS
front course inbound heading.
NOTE
VHEN EQUIPPED VITB NAV 1/NAV 2 SVITCHING AND NAV 2 IS SELECTED,
SET OBS TO THE ILS FRONT COURSE INBOUND HEADING.
2)
HEADING Selector Knob - SET BUG to provide
desired intercept angle.
3)
BC Mode Selector Button - PRESS.
Piper Models PA-46-JlOP and PA-46-350P
Airplane Flight Manual Supplement
006-0428-01
Page 14 of 39
PAA
Approved
Revision 4
•