Method; Selecting Functions; Function Selection List - IMO VXSM75-1 Instruction Manual

5. Selecting Functions

5-1

Function Selection List

Table 5-1-1 Function selection list
F: Fundamental functions
Name
F00 Data protection
F01 Frequency
command 1
F02 Operation method
F03 Maximum frequency 1
F04 Base frequency 1
F05 Rated voltage 1
(at Base frequency1)
F06 Maximum voltage
(at Maximum
frequency 1)
F07 Acceleration time 1
F08 Deceleration time 1
F09 Torque boost 1
F10 Electronic thermal
overload relay
for motor 1 (Select)
F11 (level)
F12 (Thermal time constant)
Description of change during operation
: The data changed by the
takes effect on the inverter operation.
However, press the
data.
Selecting Functions
Setting range
0: Data change enabled
1: Data protected
0: Keypad operation
1: Voltage input (terminal 12)
2: Current input (terminal C1)
3: Voltage and current input
4: Voltage input with polarity (terminal 12)
5: Voltage input inverse mode
operation (terminal 12)
6: Current input inverse mode
operation (terminal C1)
7: UP/DOWN control mode 1
8: UP/DOWN control mode 2
0: Keypad operation (direction of
rotation: input at terminal block)
1: External signal (digital input)
2: Keypad operation (forward rotation)
3: Keypad operation (reverse rotation)
50 to 400 Hz
25 to 400 Hz
0V : Voltage proportional to the
source voltage is output.
80 to 240V(200V class)
160 to 480V(400V class)
180 to 240V(200V class)
160 to 480V(400V class)
0.01 to 3600 s
0.01 to 3600 s
0: Automatic torque boost
1: Square reduction torque characteristics
2: Proportional torque characteristics
3 to 31: Constant torque characteristics
0: Inactive
1: Active (for general purpose motors)
2: Active (for forced-ventilated motors)
20 to 135% of the rated inverter current
0.5 to 10.0 min.
or key
V
key to store the new
FUNC
DATA
Min. Factory
unit setting
1
1
1
1Hz 50
1Hz 50
1V 230
1V 400
1V 230
400
0.01s 6.00
0.01s 6.00
1
1
0.01A rated
motor current
0.1min 5.0
: Press the or
V
data. The new data takes effect after the
key is pressed to store the data.
X : The data can be changed only while the
inverter is stopped.
0 X 0
0 x 0
2 x 0
x 0
x 0
X 0
X 0
6
6
0 0
1 0
6
2
key to change the
FUNC
DATA
5-1