Safety Precautions; Safety Definition; Warning Symbols; Safety Guidelines - IMO iDrive2 XKL Instruction Manual

iDrive2 inverters

1 Safety Precautions

Please read this manual carefully and follow all safety precautions before moving, installing, operating and
servicing the inverter. If ignored, physical injury or death may occur, or damage may occur to the devices.
IMO are not responsible for any physical injury or death to persons or damage to the devices if the safety
precautions in the manual are not complied with.

1.1 Safety definition

Danger:
Warning:
Note:
Qualified
electricians:

1.2 Warning symbols

Warnings caution you about conditions which can result in serious injury or death and/or damage to the equipment,
and advice on how to avoid the danger. The following warning symbols are used in this manual:
Symbols
Danger
Warning
Do not
Hot sides
Note

1.3 Safety guidelines

 Only qualified electricians are allowed to operate on the inverter.
 Do not perform any wiring and inspection or changing components when the power supply is
applied. Ensure all input power supply is disconnected before wiring and checking and always
wait for at least the time designated on the inverter or until the DC bus voltage is less than 36V.
Below is the table of the waiting time:
 Install the inverter according to manual; otherwise fire, electric shock or other injury may occur.
 The base of the heatsink may become hot during running. Do not touch to avoid injury.
Serious physical injury or even death may occur if Danger safety
requirements are not followed.
Physical injury or damage to the devices may occur if Warning safety
requirements are not followed.
Physical injury may occur if above instructions are ignored.
Only qualified Engineers with extensive knowledge and experience of
commissioning and installation should attempt to install these devices. All
safety precautions must be taken when installing.
Name
Serious physical injury or even death may
Danger
occur if requirements are not followed.
Physical injury or damage to the devices
Warning
may occur if requirements are not followed.
Electrostatic Damage to the PCBA board may occur if
discharge requirements are not followed.
Sides of the device may become hot. Do
Hot sides
not touch.
Physical injury may occur if requirements
Note
are not followed.
Inverter module
Single-phase 230V
Three-phase 400V
Instruction
0.4kW-2.2kW
0.75kW-2.2kW
4
Safety Precautions
Abbreviation
Note
Minimum waiting time
5 minutes
5 minutes