IMO iDrive2 XKL Instruction Manual page 21

iDrive2 inverters Keypad Operation Procedure
3. Set value of function code (third-level menu)
Remarks: Press both the PRG/ESC and the DATA/ENT can return to the second-level menu from the third-level
menu. The difference is: pressing DATA/ENT will save the set parameters into the control panel, and then return to
the second-level menu with shifting to the next function code automatically; while pressing PRG/ESC will directly
return to the second-level menu without saving the parameters, and keep staying at the current function code.
Under the third-level menu, if the parameter has no blinking bit, it means the function code cannot be modified.
The possible reasons could be:
1) This function code is not modifiable parameter, such as actual detected parameter, operation records and so
on;
2) This function code is not modifiable in running state, but modifiable in stop state.
Example: Set function code P00.01 from 0 to 1.
Fig 4-3 Flow diagram of modifying parameters
4.2.2 How to set the password of the inverter
IMO XKL series inverters provide password protection function for users.Use P7.00 to set a password, the
password protection becomes valid instantly after quitting from the function code editing state. Press PRG/ESC
again to the function code editing state, "0.0.0.0.0" will be displayed. Unless using the correct password, the
operators cannot enter it.
Set P7.00 to 0 to cancel password protection function.
The password protection becomes valid instantly after retreating form the function code editing state. Press
PRG/ESC again to the function code editing state, "0.0.0.0.0" will be displayed. Unless using the correct password,
the operators cannot enter it.
Fig 4-4 Flow diagram of password setting
4.2.3 How to monitor the inverter state through function codes
IMO XKL series inverters provide group P17 as the state inspection group. Users can enter into P17 directly to
monitor the state.
Fig 4-5 Flow diagram of state monitoring
21