IMO iDrive2 XKL Instruction Manual page 58

iDrive2 inverters
Function
Name
code
Multi-stage
P10.28
speed 13
Multi-stage
P10.30
speed 14
Multi-stage
P10.32
speed 15
Sudden
power loss
frequency
P11.01
decreasing
function
selection
Frequency
decreasing
P11.02 ratio of
sudden
power loss
Detailed instruction of parameters
Select at most 16 stages speed via the combination
code of S1, S2, S3, and S4.
The start-up and stopping of multi-stage running is
determined by function code P00.06, the relationship
between S1,S2,S3,S4 terminals and multi-stage speed
is as following:
S1 OFF ON OFF
S2 OFF OFF ON
S3 OFF OFF OFF
S4 OFF OFF OFF
stage 0 1 2
S1 OFF ON OFF
S2 OFF OFF ON
S3 OFF OFF OFF
S4 ON ON ON
stage 8 9 10
Setting range of P10.(2n,1<n<17): -100.0~100.0%
P11 Group Protective parameters
0: Enabled
1: Disabled
Setting range: 0.00Hz/s~P00.03 (the Max. frequency)
After the power loss of the grid, the bus voltage drops to
the sudden frequency-decreasing point, the inverter
begin to decrease the running frequency at P11.02, to
make the inverter generate power again. The returning
power can maintain the bus voltage to ensure a rated
running of the inverter until the recovery of power.
Voltage rating
Frequency-decreasing point
of sudden power loss
Note:
1. Adjust the parameter properly to avoid the stopping
caused by inverter protection during the switching of the
grid.
58
ON OFF ON OFF ON
ON OFF OFF ON ON
OFF ON ON ON ON
OFF OFF OFF OFF OFF
3 4 5 6 7
ON OFF ON OFF ON
ON OFF OFF ON ON
OFF ON ON ON ON
ON ON ON ON ON
11 12 13 14 15
230V 400V
260V 460V
Function Parameters
Default
Modify
value
0.0%
○
0.0%
○
0.0%
○
0
○
10.00Hz/
○
s