IMO iDrive2 XKL Instruction Manual page 51

iDrive2 inverters
Function
Name
code
detection
value
Energy
P08.37 Braking
enable
Energy
Braking
P08.38
threshold
voltage
Cooling fan
P08.39 running
mode
PWM
P08.40
selection
Over
P08.41 commission
selection
Detailed instruction of parameters
terminal will output the signal of "frequency arrival", see
the diagram below for detailed information:
The setting range:0.00Hz~P00.03(the Max. frequency)
Used to control the internal braking resistor.
0:Disabled
1:Enabled
Note: Only applied to internal braking resistor.
After setting the original bus voltage, adjust this
parameter to brake the load appropriately. The factory
value changes with voltage level.
The setting range:200.0~2000.0V
0: Thermal fan switching control.
1: Continuous running.
0x0000~0x0021
LED ones: PWM mode selection
0: PWM mode 1, Three-phase modulation and
two-phase modulation
1: PWM mode 2, Three-phase modulation
LED tens: low-speed carrier frequency limit
0: low-speed carrier frequency limit mode 1; when the
carrier frequency exceeds 1k at low speed, limit to 1k.
1: low-speed carrier frequency limit mode 2; when the
carrier frequency exceeds 2k at low speed, limit to 2k.
2: No limit for the carrier frequency at low speed
0:Invalid
1:Valid
51
Function Parameters
Default
Modify
value
0 ○
220V
voltage:
380.0V
○
380V
voltage:
700.0V
0
○
◎
0x01
1
◎