IMO iDrive2 XKL Instruction Manual page 40

iDrive2 inverters
Function
Name
code
Polarity of
P06.05 output
terminals
Y1 switching
P06.06
on delay time
Y1 switching
P06.07
off delay time
RO switching
P06.10
on delay time
RO switching
P06.11
off delay time
P06.14 AO output
Detailed instruction of parameters
12:Ready for operation
14:Overload pre-alarm
15: Underload pre-alarm
16:Completion of simple PLC stage
17:Completion of simple PLC cycle
18:Setting count value arrival
19:Defined count value arrival
20:External fault valid
22:Running time arrival
23:MODBUS communication virtual terminals output
Sets switching polarity of Relay and Transistor outputs.
Set Value according to normal/inverse switching
requirements.
Value RO1
0 Normal
1 Normal
4 Inverse
5 Inverse
0.000~50.000s
0.000~50.000s
The function code defines the corresponding delay time
of the electrical level change during the programmable
terminal switching on and off.
The setting range :0.000~50.000s
0:Running frequency
1:Set frequency
2:Ramp reference frequency
3:Running rotation speed
4:Output current (relative to the rated current of the
inverter)
5:Output current (relative to the rated current of the
40
Function Parameters
Default
value
Y
00
Normal
Inverse
Normal
Inverse
0.000s
0.000s
0.000s
0.000s
0
Modify
○
○
○
○
○
○