Keypad Operation - IMO iDrive2 XKL Instruction Manual

iDrive2 inverters Keypad Operation Procedure
In the stopped state, various kinds of parameters can be displayed. Select the parameters to be displayed or not
by P07.07. See the instructions of P07.07 for the detailed definition of each setting.
In the stopped state, there are 14 stopped parameters can be selected to be displayed or not. They are: set
frequency, bus voltage, input terminals state, output terminals state, PID reference, PID feedback, AI1, AI2 and the
current stage of multi-stage speeds, pulse counting value. P07.07 can select the parameter to be displayed or not
by bit and》/SHIFT can shift the parameters form left to right, QUICK/JOG(P07.02=2) can shift the parameters
form right to left.
4.2.2 Display state of running parameters
After the inverter receives valid run commands, the inverter will enter into the run state and the keypad will display
the running parameters. RUN/TUNE LED on the keypad is on, while the FWD/REV is determined by the current
running direction which is shown as figure 4-2.
In the run state, there are 22 parameters can be selected to be displayed or not. They are: running frequency, set
frequency, bus voltage, output voltage, output torque, PID reference, PID feedback, input terminals state, output
terminals state, and the current stage of multi-stage speeds, pulse counting value, AI1, AI2, percentage of motor
overload, percentage of inverter overload, linear speed. P07.05 and P07.06 can select the parameter to be
displayed or not by bit and》 /SHIFT can shift the parameters form left to right, QUICK/JOG(P07.02=2) can shift the
parameters from right to left.
4.1.3 Display state of fault
When the inverter detects a fault, it will enter into the fault pre-alarm display state. The keypad will display the fault
code and the TRIP LED will flash. The trip can be reset by pressing STOP/RST
4.1.4 Displayed state of function codes editing
In stop state, running or fault, press PRG/ESC to enter into the editing state (if there is a password, see
P07.00 ).The editing state is displayed on two classes of menu, and the order is: function code group/function
code number→function code parameter, press DATA/ENT into the displayed state of function parameter. On this
state, press DATA/ENT to save the parameters or press PRG/ESC to escape.
Fig 4-2 Displayed state

4.2 Keypad operation

Operate the inverter via keypad. See the detailed structure description of function codes in the brief diagram of
function codes.
4.2.1 How to modify the function codes of the inverter
The inverter has three levels menu, which are:
1. Group number of function code (first-level menu)
2. Tab of function code (second-level menu)
20