IMO iDrive2 XKL Instruction Manual page 42

iDrive2 inverters
Function
Name
code
QUICK/JOG
P07.02
function
QUICK/JOG
the shifting
sequence
P07.03
selection of
run
command
Detailed instruction of parameters
passwords.
Retreat editing state of the function codes and the
password protection will become valid in 1 minute. If the
password is available, press PRG/ESC to enter into the
editing state of the function codes, and then "0.0.0.0.0"
will be displayed. Unless input right password, the
operator can not enter into it.
Note: restoring to the default value can clear the
password, please use it with caution.
0: No function
1: Jogging running. Press QUICK/JOG to operate the
jogging running.
2: Shift the display state by the shifting key. Press
QUICK/JOG to shift the displayed function code from
right to left.
3: Shift between forward rotation and reverse rotation.
Press QUICK/JOG to shift the direction of the frequency
command. This function is only valid in the keypad
commands.
4: Clear UP/DOWN settings. Press QUICK/JOG to clear
the set value of UP/DOWN.
5: Coast to stop. Press QUICK/JOG to coast to stop.
6: Shift the run command source. Press QUICK/JOG to
shift the run command source.
7:Quick commission mode(committee according to the
non-factory parameter)
Note: Press QUICK/JOG to shift between forward
rotation and reverse rotation, the inverter does not
record the state after shifting during powering off. The
inverter will run according to parameter P00.13 during
next power cycle.
When P07.02=6, set the shifting sequence of run
command channels.
0:Keypad control→terminals control →communication
control
1:Keypad control←→terminal control
2:Keypad control←→communication control
3:Terminals control←→communication control
42
Function Parameters
Default
Modify
value
1
◎
0
○