IMO iDrive2 XKL Instruction Manual page 13

iDrive2 inverters
Environment
Altitude
Vibration
Installation direction
Note:
 IMO XKL series inverters should be installed in a clean and well ventilated environment according to
enclosure classification.
 Cooling air must be clean, free from corrosive materials and electrically conductive dust.
3.1.2 Installation direction
The inverter may be installed on the wall or in a cabinet.
The inverter must be installed in an upright position. Check the installation site according to the requirements
below. Refer to chapter Dimension Drawings in the appendix for frame details.
3.1.3 Installation manner
The inverter can be installed in wall mounting (for all frame sizes):
(1) Mark the hole location. The location of the holes is shown in the dimension drawings in the appendix.
(2) Fix screws or bolts to the marked locations.
(3) Position the drive onto backplate.
(4) Tighten the screws in the backplate securely.
Ensure foreign objects, such as metal, dust, oil, water can not enter into the inverter
(do not install the inverter on flammable materials such as wood);
Keep out of direct sunlight, oil mist, steam and vibration.
Below 1000m
If the sea level is above 1000m, please derate 1% for every additional 100m.
≤ 5.8m/s 2 (0.6g)
The inverter should be installed on an upright position to ensure sufficient cooling
effect.
Fig 3-1 Installation mounting
Conditions
13
Installation Guidelines