ABB Relion 670 Series Commissioning Manual page 79

1MRK 506 371-UUS E
2.1.
2.2.
2.3.
2.4. Set the
2.5.
2.6. Continue to the section
3. Set the Connection Parameters on PMU Connection Tester for UDP communication
according to the PMU configuration.
IEC140000136 V1 EN-US
3.1.
3.2.
Line distance protection REL670
Commissioning manual
Host IP to the PMU IP address configured for the port in use. Here the LANAB:1
Set
IPAddress (192.168.1.10) is set.
Port to the IED's TCP port set in the PMU under parameter C37.118TCPport (4712 is
Set
default). Alternatively, in order to make an IEEE1344 communication, the 1344TCPport
parameter setting can be used (4713 is default).
Set the Protocol as IEEE C37.118.2-2011.
Device ID Code in PMU Connection Tester per PMU Data Stream ID Number
(IDCODE). The PMU Data Stream ID Number is a user assigned ID number (1-65534) for
each data stream sent out from the PMU and it is defined under parameter
PMUdataStreamIDCODE . (Main menu/Configuration/Communication/Station
communication/phasor measurement/PMU Report/PMUREPORT:1)
Configure Alternate Command Channel is set as Not Defined . The
Make sure that the
Configure Alternate Command Channel is used to configure a TCP channel to control
the UDP data communication and transfer the header, configuration and command
frames.
Local Port to UDP destination port defined in the PMU under the parameter
Set the
UDPDestPort1 (Default value: 8910).
Click the Configure Alternate Command Channel to configure the TCP channel. A new
window will pop up. A TCP channel needs to be configured in order to control the UDP
data communicatiuon and transfer the header, configuration and command frames.
© Copyright 2017 ABB. All rights reserved
Establishing connection and verifying the IEEE C37.118/1344 communication
Verifying the IEEE C37.118/1344 TCP
Section 9
communication.
IEC140000136-1-en.vsd
73