Huawei FusionModule5000 Smart Modular Data Center Maintenance Manual page 68

SmartDC
Maintenance Guide
Impact on the System
The access control system cannot be used.
Preparations


Procedure
Step 1 Remove screws from the bottom of the access control device and remove the access control
device from the baseplate.
Figure 6-21 Removing the access control device
Step 2 Remove cables from the old access control device and connect the cables to the new one.
Step 3 Install the new access control device on the baseplate and secure the device using screws at
the bottom.
Step 4 On the ECC800 WebUI, choose Monitoring > System > ECC800 > Controls > Delete
device with communication failure, and click Submit.
Step 5 Log in to the ECC800 WebUI, choose System Settings > Access Right Management, and
perform the Synchronize Permission operation.
Step 6 Verify that the access control system is normal.
----End
Issue 04 (2020-03-25)
Tools: ESD wrist strap, ESD gloves, flat-head screwdriver, Phillips screwdriver, labels,
marker
Material: access control device
Copyright © Huawei Technologies Co., Ltd.
6 Parts Replacement
61