Huawei FusionModule5000 Smart Modular Data Center Maintenance Manual page 47

SmartDC
Maintenance Guide
 In ECC800 V100R002C10 and earlier versions, the default IP address of port WAN_1 is
192.168.1.10.

The WAN1 port IP address cannot be set to an IP address in any of the following network
segments: 192.168.0.x, 192.168.245.x, 192.168.246.x and 192.168.248.x.
 IP addresses for the WAN1 and WAN2 ports should not be set in the same network
segment.

In some customized scenarios, the default IP address for the WAN_2 port is
192.168.248.10. The default value prevails.

WAN ports support the Internet access and LAN ports support the intranet access. Connect
the PC network port to the WAN port or LAN port on the ECC800-Pro based on the access
network.
Step 2 Configure the PC IP address and the WAN1 IP address in the same network segment.
If the WAN1 port IP address is 192.168.8.10, subnet mask is 255.255.255.0, and default
gateway is 192.168.8.1, set the PC IP address to 192.168.8.12, subnet mask to 255.255.255.0,
and default gateway to 192.168.8.1.
Step 3 Set LAN parameters.
1.
2.
3.
4.
5.
Issue 04 (2020-03-25)
 If the ECC800-Pro connects to a LAN and a proxy server has been selected, perform
Step 3.4.
 If the ECC800-Pro connects to the Internet, and the PC in a LAN accesses the Internet over a proxy
server, do not perform
Open the Internet Explorer and choose Tools > Internet Options.
Click the Advanced tab and select Use TLS1.1 and Use TLS1.2.
(Optional) Click the Connections tab and select LAN settings.
(Optional) On Proxy server, clear Use a proxy server for your LAN.
Click OK.
Copyright © Huawei Technologies Co., Ltd.
Step 3.3 and Step 3.4. Otherwise, you will fail to access the ECC800-Pro.
6 Parts Replacement
Step 3.3 and
40