Operation - Sharp V-1 General & Electrics Manual

SHARP

4.6 OPERATION

4.6.1 WARNINGS
1. Beware of loose or long hair near the working area to avoid unnecessary accident from
happening.
2. Do not wear gloves when operating the machine, otherwise it will cause dangers.
3. Always handle large work pieces with appropriate manpower.
4. Only qualified people are allowed to operate the forklift truck, crane, lifting equipment
and other materials handling equipment.
5. Never open the guarding doors while machining.
6. Ensure the work piece has been clamped firmly and properly on the holding device
before machining the work piece.
7. Stop the machine before adjusting the coolant nozzles.
8. Do not touch or reach over rotating or moving objects.
9. Do not remove any safety equipment.
10. Always use the proper tools, instead of using your hand, to remove the chip from the
cutting tool.
11. Do not install or remove the cutting tool and other tool holding equipment unless the
machine is fully stopped.
12. Always wear appropriate protective equipment while working in a dusty environment.
13. Ensure to open the dust collecting equipment and wear a safety mask while machining
the work piece made with graphite or any other materials might generate powder chip.
14. Always use the appropriate lifting equipment to handle the loads, and beware of the
surroundings while operating the lifting equipment to prevent crashing and damaging.
15. Ensure the chips do not pile up so that might cause fire while doing a heavy-load
machining.
V-1 KNEE MILL GENERAL MANUAL
CH4-6 KRDM24C0 V4.0S