Quill Removal - Sharp V-1 General & Electrics Manual

SHARP

7.9 QUILL REMOVAL

1. Remove screw 'D' and ball reverse lever 'E'.
2. Remove circlip 'F', screw 'G' and arm 'H'.
3. Thread shaft 'J' through micro nuts and remove.
4. Remove screw 'K' and stop 'L'.
5. Remove quill
6. Clean all areas, oil liberally and reassemble.
7. Check correct operation of feed trip linkage. See instruction on sketch #30.
Re-assembly of spline alignment. See sketch #31.
V-1 KNEE MILL GENERAL MANUAL
CH7-13 KRDM24C0 V4.0S