The Machine Maintenance - Sharp V-1 General & Electrics Manual

SHARP

7.10 THE MACHINE MAINTENANCE

Ensure to turn off the main power switch, the power switch of the machine panel and
main power circuit breaker and put "Under maintenance, Do not touch any power switch"
warning signs on visible spots before starting the maintenance work.
7.10.1 NOTICES
1. Only qualified engineers are allowed to maintain or install the electrical equipment.
2. Do not remove or alter any over-traveling limit switch and related mechanical parts
without permission.
3. Always use ladders when working in the high place.
4. Ensure all the appliances, such as fuse, cable, etc., are reliable.
7.10.2 CLEANING RULE
1. Ensure to clean up the anti-rust treatment with the kerosene or the diesel on the
contact surfaces of the moving machine parts. Don't clean up the anti-rust solvent on
other places than where mentioned above.
2. Do not clean the machine with organic solvent.
3. Do not use compressed air to remove the dust on the machine, which might damage
surfaces among sliding parts.
4. Remove all the anti-moisture substances placed inside the enclosures.
5. Always clean up the working area and machine after the maintenance job is done.
Keep the machine and work area neat, clean, dry and orderly.
6. Remove all the garbage and leftover after the maintenance work is done.
7. Always keep the maintenance records and inspection results.
8. Report to our local dealer or us if any abnormal condition was found during
maintenance. Do not disassemble the machine by yourself.
V-1 KNEE MILL GENERAL MANUAL
CH7-14 KRDM24C0 V4.0S