Sharp V-1 General & Electrics Manual page 52

SHARP
6. Check the coolant level of the cutting water tank regularly. Fill it up if necessary.
7. Always wear the correct protection outfit, such as safety goggles, oil-proof safety shoes,
safety uniform, etc. before starting the machine.
8. Ensure all the doors and shields of the machine, the operating panel and the main
power supply panel are closed before starting up the machine.
9. Ensure all the machine parts are secured and fixed properly.
10. Check all the switches, push buttons and operating levers to make sure they could be
operated smoothly.
11. Ensure turn off the spindle CW/CCW select switch before press the spindle button on the
operating panel.
12. Ensure turn off the ON/OFF switch on the power feed before press the power feed on
button on the operating panel.
13. Ensure the standby signal light is luminous after switching on the main power supply.
14. Ensure the electrical cabinet,door of operating panel and other safety guarding are closed.
15. Always clean and lubricate all the sliding surfaces before starting up the machine if the
machine is just unpacked or has not been used for a long time. Ensure to run the
lubrication system for a while until all the sliding parts are lubricated adequately before
starting up this machine.
16. Always use the proper type of lubrication oil as indicated in the nameplate or the
manual.
17. To turn on the main power, the procedures below must be following
Turn on the factory's main power supply ( switch "ON" the circuit breaker of the
machine's main power supply ( release the E-STOP button on the operating panel.
V-1 KNEE MILL GENERAL MANUAL
CH4-3 KRDM24C0 V4.0S