General Principles Concerning Operator Safety For This Machine - Sharp V-1 General & Electrics Manual

SHARP
1.8 GENERAL PRINCIPLES CONCERNING OPERATOR
SAFETY FOR THE MACHINE
1. Do not wear rings, watches, ties or loose sleeved clothing.
2. Always use the recommended or equivalent hydraulic oil, lubricant oil and grease.
3. The working table adjacent to the machine should be secured to prevent the workpiece
room falling onto the machine.
4. Ensure the machine is stopped and the power is off before replacing the fuse.
5. Always use the fuse with the same specification for replacement.
6. Do not use other workholding devices without checking for compatibility with these mill.
7. Do not touch the switch with wet hands that could result in electric shock.
8. Do not touch the electric equipment and operating panel with wet hands, this could
result in electric shock.
9. Do not grip a component with grease or oil on it.
(a) Grip all components firmly.
(b) Do not attempt to hold components that are too awkward or too difficult to hold.
(c) Do not hold components that are too heavy for the machine.
(d) Know how to hold components properly when lifting.
10. Be sure to clean oil or grease from hand tools, levers and handles.
11. Be sure there is enough texture on the surface of the hand tool or lever handle for
proper safe hand contact.
12. Grip hand tools and lever handles firmly.
(a) Always choose the proper hand tool and appropriate grip position on the lever
handle.
(b) Do not use hand tools or lever handles in an awkward position.
(c) Do not apply excessive force.
13. Always use the recommended gripping position to grasp hand tools and lever handles.
14. Do not use broken, chipped or defective tools.
15. Be sure that the workpiece is immobile in vice or other holding device.
V-1 KNEE MILL GENERAL MANUAL
CH1-6 KRDM24C0 V4.0S