Sharp V-1 General & Electrics Manual page 58

SHARP
4.6.5 CLAMPING TABLE
Ifoperator don't use longitudinal table feed, it can be clamped to add rigidity. This can
decrease vibration when doing heavy cut. The clamping table locking lever is located on the
front of saddle. Ensure to use asequately clamping pressure to set it, otherwise excessive
pressure will broke the clamping parts.
4.6.6 CLAMPING SADDLE
If operator don't use saddle feed, it can be clamped to add rigidity. This can decrease
vibration when doing heavy cut. The clamping saddle locking lever is located on the left side
of saddle. Ensure to use adequately clamping pressure to set it, otherwise excessive pressure
will broke the clamping parts.
V-1 KNEE MILL GENERAL MANUAL
CH4-9 KRDM24C0 V4.0S