Adjustment Of Backlash - Sharp V-1 General & Electrics Manual

SHARP

6.5 ADJUSTMENT OF BACKLASH

To adjust backlash, the procedures below must be following:
1. Move the table or saddle to middle position.
2. Withdraw handwheel
3. Move table or saddle to the location that you can see screws A .
4. Loosen the screw
5. Tighten the nut
6. Tighten the screw
7. Install the all parts.
C and 3 screw
A .
B unit 0.08-0.12mm.
A .
V-1 KNEE MILL GENERAL MANUAL
D .
CH6-5 KRDM24C0 V4.0S