Sharp V-1 General & Electrics Manual page 68

SHARP
4.9.1 NOTICES
1. Ensure to turn off the power supply of the machine and put "Under Maintenance. Do
not turn on the power supply" warning signs on visible spots before cleaning the
machine or accessories. Ensure the machine is fully stopped before maintaining the
machine.
2. Ensure to clean the machine and its surroundings and put everything in order after the
machining job is done. Ensure to put anti-rust oil on the machine bed and all the
moving parts to keep them from rust and dirt.
3. The machine moving parts should be returned to the adequate location.
4. Check and replace the broken wipers.
5. Check and replace the lubricant or hydraulic oil if they are dirty or emulsify.
6. Check and replace the coolant if they are dirty.
7. Check and refill the lubricant, hydraulic oil and coolant if necessary.
8. Clean the filters of the lubrication, hydraulic, and cutting cooling systems.
9. Turn off all the power switches and main power circuit breakers when leaving the
machine unattended.
V-1 KNEE MILL GENERAL MANUAL
CH4-19 KRDM24C0 V4.0S