Sharp V-1 General & Electrics Manual page 66

SHARP
4.6.16 HAND QUILL FEED TWO
To operate feed by quill feed handle, the procedures below must be following:
Ensure the spindle is full stop and the quill lock 16 is off ( use the micrometer dial 15
to set travel ( set the quill feed control lever 8 at location OUT
quill feed handle 14 control.
4.6.17 INSTALL THE TOOL
The specification of drawbar
/16 -20NF ( R8 ), M16-P2.0 ( ISO40 ), 5/8 -11NC ( ISO40 ). When tightening or loosing the
drawbar it is necessary to lock the spindle. Use the spindle brake 5 to lock the spindle.
1. To tight the tool, the procedures below must be following:
Use spindle brake to lock the spindle ( use spanner to turn the drawbar clockwise until
tighttening tool.
2. To loose the tool, the procedures below must be following:
Use spindle brake to lock the spindle ( use spanner to turn the drawbar
counterclockwise ( use mallet tap the drawbar to loose the tool ( turn the drawbar
counterclockwise until loosening the tool.
WARNING !!!
Do not install the tool when spindle is running. Otherwise might cause
serious accident.
10 is M12-P1.75 ( ISO30 ), 1/2
CH4-17
V-1 KNEE MILL GENERAL MANUAL
( the quill is under the
-12NC ( ISO30 ) or 7
KRDM24C0 V4.0S