Sharp V-1 General & Electrics Manual page 41

SHARP
3.4.2 POWER WIRING
Follow the instructions below to wire power
1. Ensure the electrical cables have the same or better power rating as prescribed in the
electrical document.
2. Only qualified engineers are allowed to connect the power cable of this machine.
3. Do not connect any power cable that might generate signal noises on the power panel
of this machine.
4. Do not connect the power cable of this machine to any power source or power panel
that might cause an abrupt voltage drop.
5. Remove all the anti-moisture substances placed inside the cabinets or panels.
6. Ensure to turn off all the power supplies and place "Under Installation High Voltage
Equipment. Do not turn on the Power" warning signs in front of the main power supply
switch before connecting the power supply.
WARNING !!!
Only qualified engineers are allowed to install or maintain the electrical
equipment of this machine. Failure to do so will result in a serious accident.
V-1 KNEE MILL GENERAL MANUAL
CH3-8 KRDM24C0 V4.0S