Lubrication - Sharp V-1 General & Electrics Manual

SHARP

7.3 LUBRICATION

7.3.1 THE OIL GUIDE TABLE
7.3.1.1 OIL GUIDE TABLE A (For all machine type)
Lubricant Position
Lubricant
Characteristic
Lubrication Method
Replace& add Period
Tank Capacity
Recommended
Grade of Oil
**** This is recommended that use ISO68 grade of oil for Slideway and Ballscrew if
this machine is located in a plant with ambient temperature of under 25 ° ° ° ° C.
Lubrication Tank
Slideway and Ballscrew
Viscosity ISO VG68
ŁAnti-wear,
Extreme-pressure
Centralized Lub
Daily
As needed
3 Liters
BP Macurrat D 68
ŁMobil Vactra No.2
ŁShell Tonna S2 M68
ŁBECHEM Staroil
CGLP 68 MF
CH7-4
V-1 KNEE MILL GENERAL MANUAL
(V2.7)
Cutting Coolant
Good Heat
conduction
ŁGood lubricant
performance
Circulating Lub
As needed
100 Liters
Depend on Model
CPC Cutting Oil 31C
ŁShell Dromus B
or Macron 32
ŁBECHEM AVANTIN
KRDM24C0 V4.0S