Installation Location - Sharp V-1 General & Electrics Manual

SHARP

3.2 INSTALLATION LOCATION

To upgrade the operation efficiency and accuracy of this machine, a proper foundation is
required.
It is recommended that this machine should be located in a plant with ambient
temperature of around 20 °C, and without the influence of dampness, chemical gas
or trembling.
1. Do not install the machine in a location near vibration sources, such as air compressor,
punch press, etc. Otherwise poor machining accuracy may result.
2. Do not expose this machine and its NC controller to direct sunlight, moisture, etc.
3. Keep this machine away from flying powder, corrosion substances, etc.
3.2.1 ENVIRONMENTAL REQUIREMENT
This machine should be installed under the right environments as following
1. Supply voltage 90% to 110% of the rated voltage.
2. Source frequency Rated frequency D 1 Hz.
3. Ambient temperature
4. Altitude: shall be at altitudes up to 1000m above mean sea level.
5. Relative humidity – less than 90%, and not exceed 50% at 40° C.
The moisture condense to water drop due to emperature alternation is unacceptable.
6. Atmosphere: Free from excessive dust, acid fume, corrosive gases and salt.
7. Do not expose the machine directly under sunlight or heat source, which might result in
considerable environmental temperature changes.
8. Do not place the machine near any abnormal vibrations.
9. Do not place this machine near the magnetic and static electric fields.
10. Do not place this machine near the air compressor and presser.
5 C C to 40 C C .
CH3-4
V-1 KNEE MILL GENERAL MANUAL
KRDM24C0 V4.0S