Sharp V-1 General & Electrics Manual page 20

SHARP
53. Always use the correct equipment.
54. Never take cuts beyond the machine's capability.
55. Never use excessive forces in polishing, filing.
57. Always use the proper hand tool to remove swarf.
(a) Never hurry to remove swarf.
(b) Beware of swarf wrapped around the spindle or workpiece.
58. Beware of tools or machine parts falling on controls.
59. Do not change the original setting parameters unless it is necessary. Always keep
records of the original setting values before change.
59. Do not blur, block or take away any however according to set-back afterward plate and
sign for warning
purchase a new plates or signs.
60. Disconnect the circuit breaker of the main power immediately if the power supply is
short or unsteady.
notice danger. Please contact us or our local dealer or distributor to
V-1 KNEE MILL GENERAL MANUAL
CH1-9 KRDM24C0 V4.0S